Opscraft
IP addressing & subnetting · Lesson 6 of 9 · 3 min read

IPv6 essentials

Format

  • 128 bits, written as eight groups of four hex digits: 2001:0db8:0000:0000:0000:ff00:0042:8329.
  • Compression: drop leading zeros in a group (0db8 → db8), and replace one run of all-zero groups with :: → 2001:db8::ff00:42:8329.
  • Prefix notation as in IPv4: 2001:db8:abcd::/48. A standard LAN subnet is /64 (64 bits network, 64 bits interface ID).
Enlarge diagramsite prefix /48 (from the provider)subnetinterface ID (64 bits)2001:db8:abcd00120000:0000:0000:0001Shorten: drop leading zeros in a group, and replace one run of zero groups with ::2001:db8:abcd:12::1
Figure 1. An IPv6 address is 128 bits. A typical layout: the provider assigns a prefix, you number subnets, and each LAN subnet is a /64.
Swipe sideways to see all of it, or tap to open it full screen.

Address types

Type Prefix Notes
Global unicast 2000::/3 Publicly routable
Link-local fe80::/10 Every interface has one; not routed
Unique local (ULA) fc00::/7 Private-like, not routed on the internet
Multicast ff00::/8 IPv6 has no broadcast; multicast replaces it
Loopback ::1
Unspecified ::

Hosts can configure themselves with SLAAC (from router advertisements) or DHCPv6. ARP is replaced by Neighbor Discovery (ICMPv6) — so blocking ICMPv6 breaks IPv6.

IPv6 in AWS and Kubernetes

  • VPCs can get an Amazon-provided /56 (or BYOIP); subnets get /64s. Dual-stack or IPv6-only subnets are supported.
  • IPv6 addresses are globally unique — there's no NAT. For outbound-only internet access use an egress-only internet gateway (stateful, blocks inbound initiation). NAT64/DNS64 lets IPv6-only workloads reach IPv4 services.
  • EKS IPv6 clusters give each pod an IPv6 address from the node's prefix — practically unlimited pod IPs, solving IPv4 exhaustion (with some ecosystem caveats).
  • With AWS now charging for public IPv4 addresses, IPv6 has a cost angle too.