IPv4 structure and binary
IP addressing questions are quick arithmetic once you can see addresses in binary, remember the class and private ranges, and use the block-size trick. Interviewers use them as a fundamentals check ("how many usable hosts in a /27?", "is this address in that subnet?"), and in AWS the same maths decides how you size VPCs and subnets — which matters a lot on EKS, where every pod consumes a VPC IP. This topic takes you from binary basics to planning IP space for a multi-account AWS organisation.
The address
An IPv4 address is 32 bits, written as four octets (8 bits each) in dotted decimal: 192.168.10.77. Each octet ranges from 0 to 255. Total address space: 2³² ≈ 4.29 billion addresses — not enough for the modern internet, hence NAT, private ranges and IPv6.
Binary conversion
Each bit in an octet has a place value:
| Bit | 128 | 64 | 32 | 16 | 8 | 4 | 2 | 1 |
|---|---|---|---|---|---|---|---|---|
To convert decimal → binary, subtract place values from the left:
- 192 = 128 + 64 →
11000000 - 168 = 128 + 32 + 8 →
10101000 - 10 = 8 + 2 →
00001010 - 77 = 64 + 8 + 4 + 1 →
01001101 - 255 →
11111111; 0 →00000000
So 192.168.10.77 = 11000000.10101000.00001010.01001101.
Memorise the mask-octet values — sums of leading 1-bits:
| Bits set | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
|---|---|---|---|---|---|---|---|---|
| Octet value | 128 | 192 | 224 | 240 | 248 | 252 | 254 | 255 |
Network part and host part
A subnet mask (or prefix length) splits the address into:
- the network portion — identifies the subnet (all hosts in a subnet share it);
- the host portion — identifies the device within the subnet.
192.168.10.77/24 → mask 255.255.255.0 → network 192.168.10.0, host .77.
Computing the network address is a bitwise AND of the address and mask:
address 11000000.10101000.00001010.01001101 192.168.10.77
mask 11111111.11111111.11111111.11100000 255.255.255.224 (/27)
AND 11000000.10101000.00001010.01000000 192.168.10.64 ← network
Two hosts can talk directly (without a router) only if they're in the same subnet — same network portion under the mask. Otherwise traffic goes through the default gateway, which itself must be inside the host's subnet.